SCX11 to Arduino

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
Post Reply
NIUseniordesign
Posts: 1
Joined: Tue Apr 07, 2020 1:50 pm

SCX11 to Arduino

Post by NIUseniordesign » Tue Apr 07, 2020 1:55 pm

Hello,
I have been trying to save a program to a sequence in the SCX11 controller. I can call up the code on my PC but want to use the I/O pins to call the code for me. Currently this is being done by an Arduino and a 5V signal being sent to the pin. My issue is that I can not seem to figure out how to save the sequence to the corresponding pin. Is this possible to do?

om_tech_support_KR
Posts: 87
Joined: Thu Jan 11, 2018 3:03 pm

Re: SCX11 to Arduino

Post by om_tech_support_KR » Wed Apr 08, 2020 10:24 am

Hello,

When you save the program to the SCX11 controller you assign it a sequence number. If you want to run it off 1 input you can assign it sequence number 0 then when you turn on the START input it will run it. You will have to assign one of the I/O to START. This can be reference on page 129 in the manual. If you would like the program to run at power up you can name the sequence CONFIG this is referenced on page 122.

https://www.orientalmotor.com/products/ ... 60080E.pdf

Post Reply