BLV Series Wiring Clarifications

Discuss Brushless DC Motor Speed Control Systems or AC Motor Speed Control systems and related Accessories here.
Posts: 3
Joined: Tue Oct 02, 2018 9:45 pm

BLV Series Wiring Clarifications

Postby Mr.Thota » Tue Mar 12, 2019 6:08 am

Hi !!

We required your assistance for installtion of BLV620K100S-3, so please let us know brief wiring details to proceed further in this matter.

As we are using for simple conveyor for forward & reverse directional application only, through potentiometer we will vary the speed.

Hope we need to connect the following:

CN4 connector from driver:
5 is ----common
1+4---- need to be shot for forward direction
2+4---- need to be shot for reverse direction

11 + 12 + 13 is for external potentiometer

Apart this, all the switches (SW1 +SW2 + SW3) should be by default factory settings only right ??

Posts: 24
Joined: Thu Jan 11, 2018 3:03 pm

Re: BLV Series Wiring Clarifications

Postby om_tech_support_KR » Tue Mar 12, 2019 7:19 am

Hi Mr.Thota,

On the CN4 connector for the forward direction pins 1(FWD) and 4(M0) would have to be shorted to pin 5(IN-COM). For reverse direction pins 2(REV) and 4(M0) would be shorted to pin 5(IN-COM). The potentiometer would go the pins 11, 12 and 13 and the switches would be set to the factory setting. Reference the link below for a wiring example. ... df#page=27

Return to “Speed Control Systems”

Who is online

Users browsing this forum: No registered users and 3 guests