Discuss AC Induction motors, Reversible motors, Synchronous motors, Low-Speed Synchronous motors, Torque motors, Gearheads, Brake Packs and related Accessories here.
2 posts • Page 1 of 1
I am looking at using a 41K25GN motor/gearhead with the shaft in a vertical orientation. Is this a problem? I know that oil filled gearboxes need to be specified to be used like this so that the oil does not leak, but I do not see anything in your literature that warns against using it in this manner. The load is very light, less than 3 pounds, so I am not too worried about thrust loading the bearings.
Who is online
Users browsing this forum: No registered users and 2 guests