emp 402 serial pc control

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
Posts: 1
Joined: Wed Feb 22, 2017 3:27 am

emp 402 serial pc control

Postby axlpotito » Wed Feb 22, 2017 3:31 am


I am noob in Controllers and pc control. I have to control an EMP 402 controller through a C++ PC program, that I've already almost written. Can you explain how to do this or say if there already exist some drivers.

Thank you so much

Posts: 192
Joined: Tue May 10, 2016 4:48 pm

Re: emp 402 serial pc control

Postby om_tech_support_JS » Thu Feb 23, 2017 1:54 pm

Hi axlpotito,

The EMP402 controller uses RS232C communication in order to write sequences to the controller. You will need to follow the appropriate command syntax in order for the controller to accept the sequence which you write. You can reference section 9 (starting on page 53) of the manual linked below for further information on the command syntax:
http://www.orientalmotor.com/products/p ... 036-3E.pdf

In order to write the sequences to the driver, you will need to use a terminal software that uses RS232C communication. An example of this terminal software is Tera Term.

Return to “Stepper Motors and Controls”

Who is online

Users browsing this forum: No registered users and 7 guests