Hey everybody
I confuse to wiring scx11 to nxd20-c
Refer to startup manual of scx11 page 5
It says scx11 must set the switch setting to 5v
But in my case i want to control via plc to i/o port off scx11 ,and my plc logic voltage is 24 volt
Please help me
Thanks
Wiring scx11 to nxd20-c
-
- Posts: 20
- Joined: Thu Jan 11, 2018 3:03 pm
Re: Wiring scx11 to nxd20-c
Hi Denny,
The 5/24 VDC and Sink/Source switches are for the settings of the driver being used with the SCX11 controller. Those switches are for the Driver connector on the SCX11 they don't affect the I/O connector. For your PLC when wiring to the I/O connector on the SCX11 you can use 5-24 VDC reference the link below for connection example.
https://www.orientalmotor.com/products/ ... df#page=32
The 5/24 VDC and Sink/Source switches are for the settings of the driver being used with the SCX11 controller. Those switches are for the Driver connector on the SCX11 they don't affect the I/O connector. For your PLC when wiring to the I/O connector on the SCX11 you can use 5-24 VDC reference the link below for connection example.
https://www.orientalmotor.com/products/ ... df#page=32
Re: Wiring scx11 to nxd20-c
Is this the only connection valid for this or are there other examples? I'd appreciate a couple of options if possible at all.
-
- Posts: 20
- Joined: Thu Jan 11, 2018 3:03 pm
Re: Wiring scx11 to nxd20-c
Hi NedWil,
For wiring your PLC to the I/O connector on the SCX11 you can either wire it in sink configuration which is shown on page 32 or source configuration shown on page 33.
https://www.orientalmotor.com/products/ ... df#page=32
For the wiring examples from the SCX11 to the NX driver reference page 63 for sink wiring and page 64 for source wiring. Remember to set the SINK/SOURCE switch to configuration being used and set the 5/24 V switch to 5V.
https://www.orientalmotor.com/products/ ... df#page=63
For wiring your PLC to the I/O connector on the SCX11 you can either wire it in sink configuration which is shown on page 32 or source configuration shown on page 33.
https://www.orientalmotor.com/products/ ... df#page=32
For the wiring examples from the SCX11 to the NX driver reference page 63 for sink wiring and page 64 for source wiring. Remember to set the SINK/SOURCE switch to configuration being used and set the 5/24 V switch to 5V.
https://www.orientalmotor.com/products/ ... df#page=63
Return to “Stepper Motors and Controls”
Who is online
Users browsing this forum: No registered users and 6 guests