Hi,
I have direct input IN2 configured to +JOG, when I apply power to IN2 I see it activated in MEXE02 status monitor
but I get no motion from the stepper. If I go to Teach Mode I am able to move the stepper.
-Thomas
AR - Direct Input JOG
-
om_tech_support_KR
- Posts: 146
- Joined: Thu Jan 11, 2018 3:03 pm
Re: AR - Direct Input JOG
Hi Thomas,
For the +JOG input this would move the motor the JOG travel amount programmed which is 1 step for the factory setting. This is referenced on page 96 of the manual that I will link below. For a continuous jog in the positive direction you should use the FWD input. This would run at the speed set in the operation data points. This is referenced on page 95.
For the +JOG input this would move the motor the JOG travel amount programmed which is 1 step for the factory setting. This is referenced on page 96 of the manual that I will link below. For a continuous jog in the positive direction you should use the FWD input. This would run at the speed set in the operation data points. This is referenced on page 95.