Help me connect this driver...

Discuss Stepper motors, Drivers, Controllers, GUI's and related Accessories here.
Jwalter007
Posts: 1
Joined: Tue Mar 12, 2019 12:23 pm

Help me connect this driver...

Postby Jwalter007 » Wed Mar 13, 2019 5:11 am

I have a stepper motor driver that came out of a chinese built machine. I am stealing some of its parts for a new project.
I'm planning to use the stepper motor and its driver which is a model ATMH-4A/21x
I have found some sellers for this on alibaba, but no documentation.

My end result for this would be to have a way to set and adjust the speed of the stepper motor.
I'm planning to use it to cut a piece of candy which is being extruded.
The stepper will have a rotating cutter. The candy will extrude and be cut by the cutter which will be speed adjusted to provide me the end candy weight that I desire.

I have the correct input power and output connector for the motor. I can't figure out what the labels for the middle connector are.
I've attached some images.
Thanks

om_tech_support_KR
Posts: 24
Joined: Thu Jan 11, 2018 3:03 pm

Re: Help me connect this driver...

Postby om_tech_support_KR » Wed Mar 13, 2019 7:53 am

Hi Jwalter007,

Unfortunately since these products aren't ours we won't have any documentation on them. If the motor is a 2 phase stepper we have a wiring configuration for our motors that you can reference below.

https://catalog.orientalmotor.com/Asset/con_pk2.jpg


Return to “Stepper Motors and Controls”

Who is online

Users browsing this forum: No registered users and 8 guests