BLV R

[Tridacsolution]

Hi
I am using BLV R series drive, how to take speed output in this?

[om_tech_support_KR]

Hello,

To read the speed you will have to read the Actual velocity register referenced on page 273 of the manual via RS-485 Modbus RTU. Note this will give you the speed at the moment its read it will not continuously update. From the outputs you can look at the VA or ZV parameters. VA turns ON when the operating velocity reaches the target velocity. This is referenced on page 176. ZV turns ON when the actual velocity is equal to or less than the "ZV detection speed range" parameter with the velocity 0 as a center. This is referenced on page 177.

https://www.orientalmotor.com/products/ ... f#page=273

[Tridacsolution]

Hi

Thank you for the information,
is it possible to take position feedback in BLV-R Series?

[om_tech_support_KR]

Hello,

You can read the position feedback with the Actual position register also on page 273.