Page 1 of 1

Holding torque of a reversible motor

Posted: Wed May 08, 2013 3:29 pm
by om_tech_support_JT
Q: What is the holding torque of your world K series AC reversible motors?

A: The holding torque generated by the friction brake in our AC reversible motors is about 5 oz-in (reference). It can be increased with a gearhead. The holding torque off the gearhead shaft will be 5 oz-in x gear ratio x gear efficiency.

Please see PAGE C-14 of the literature linked below for our GEARHEAD EFFICIENCY:
http://www.orientalmotor.com/products/p ... _intro.pdf

It is important to note that the holding torque generated by our reversible motors typically isn't enough to hold a vertical load in place. If you need to hold a load in place, I would recommend looking at our AC electromagnetic brake motors.

ELECTROMAGNETIC BRAKE MOTORS:
http://www.orientalmotor.com/products/p ... 6-200w.pdf
-we show the holding torque in the specifications for each motor.

Re: Holding torque of a reversible motor

Posted: Mon May 23, 2016 9:05 pm
by aldoned
Thanks for the info