I'm giving a one-second delay before feeding pulses to different direction pin even then, same behavior is exhibited. The Motor used is PKP245D23B2 and the start frequency for it is well above 300RPM which is what I'm using by feeding 1KHz pulses.
Search found 2 matches
Search found 2 matches • Page 1 of 1
- Thu Jun 10, 2021 2:51 am
- Forum: Stepper Motors and Controls
- Topic: Driver Does not respond to pulses
- Replies: 3
- Views: 41
Hi, I'm using CVD223-K 2 phase stepper motor driver with a 2 phase Oriental stepper motor. I tried to interface the driver's Direction pins i.e. CW and CCW with a PSOC MCU's GPIO. The driver's DIP switch settings were as follows, 2 pulse mode enabled Smooth Drive ON Rest of the switches are towards ...