Search found 4 matches

by markus506
Wed Oct 23, 2019 10:08 am
Forum: Servo Motors & Controls
Topic: Minimum wiring required between SCX11 and NXD75-s
Replies: 3
Views: 1784

Re: Minimum wiring required between SCX11 and NXD75-s

Thank you very much for the information. When looking at the NX manual (specifically page 45 for position and 47 for torque), I assume that any of the signals labelled with an '*" are optional? At least, I am assuming that based on the footnote on the page saying that they are effective if changed b...
by markus506
Wed Oct 23, 2019 4:54 am
Forum: Servo Motors & Controls
Topic: Minimum wiring required between SCX11 and NXD75-s
Replies: 3
Views: 1784

Minimum wiring required between SCX11 and NXD75-s

Hi there, Using the NXD75-s and an NXM940A motor in my first application. I require the motor to operate in torque control mode. I plan on programming the NXD75-s using the MEXE02 software. I am wondering what the absolute minimum wiring required is for connector CN7. I purchased an SCX11 for this, ...
by markus506
Mon Oct 07, 2019 9:50 am
Forum: Servo Motors & Controls
Topic: Multiple NXM65A-PS10 control
Replies: 2
Views: 1316

Re: Multiple NXM65A-PS10 control

Thanks!
by markus506
Mon Oct 07, 2019 6:57 am
Forum: Servo Motors & Controls
Topic: Multiple NXM65A-PS10 control
Replies: 2
Views: 1316

Multiple NXM65A-PS10 control

Hi,

We are developing a system that uses 2-3 of the NXM65A motor/planetaries. To confirm, each motor requires a drive and controller? For example, if I purchased 3 of the motors, I would need 3-NXD20-C drives and 3-SCX11 controllers (1 drive and 1 controller per axis)?

Thanks!