Search found 5 matches

by om_tech_support_CF
Fri Feb 21, 2020 2:34 pm
Forum: Stepper Motors and Controls
Topic: Indirect Reference Resigsters
Replies: 0
Views: 908

Indirect Reference Resigsters

Q: I am trying to use the Indirect Reference Address Settings to read from different registers via RS-485 Modbus RTU on my AZD-KD. I would like to read the Driver Output Status and the Detection Position. How can I do this? A: Indirect Reference Address Settings can be used to read / write to regist...
by om_tech_support_CF
Thu Jan 16, 2020 8:58 am
Forum: Stepper Motors and Controls
Topic: Looping More than 256 Times
Replies: 0
Views: 942

Looping More than 256 Times

Q: I have an EZS actuator that I need to loop 7000 times from a home location to the full stroke, then slowly return back home after the loop cycle is complete. How can I do this? A: Below you can see example parameters that need to be set in order to complete this loop function. 1. Change your oper...
by om_tech_support_CF
Thu Jan 09, 2020 8:27 am
Forum: Stepper Motors and Controls
Topic: Adding Logic Instruction for Ethernet / IP on Studio 5000
Replies: 0
Views: 1035

Adding Logic Instruction for Ethernet / IP on Studio 5000

1. After setting up your PLC and AZD-AEP or AZD-CEP Driver open the Main Routine. (Note: you do not need to add AOI’s for this). 2. Add a Normally Open Instruction to your rung and pick your desired name. For this example, this Instruction will be used to activate the Forward Jog tag, so I named it ...
by om_tech_support_CF
Tue Jan 07, 2020 2:04 pm
Forum: Stepper Motors and Controls
Topic: Unique Driver Identifier
Replies: 0
Views: 1028

Unique Driver Identifier

Q: I have several AZD-AX Drivers hooked up to a common network at different locations throughout the country that I access remotely. Each driver performs a different motion profile. Is there a way I can read a register from the drive via Modbus-RTU to determine which drive is which? I would prefer a...
by om_tech_support_CF
Mon Jan 06, 2020 12:51 pm
Forum: Stepper Motors and Controls
Topic: AZD-KD Current Draw
Replies: 0
Views: 1017

AZD-KD Current Draw

Q: I have an AZD-KD Driver that has power and allows me to write to the drive, but when I try to jog the motor via teaching mode, I get the error “Main Power Supply Off.” I have my driver connected to a 24 VDC 3.0 A power supply. I am using the EZSM6E040AZMK. A: Your power source does not have enoug...