Using the TMP-1 Torque Motor Controller to Stop a Motor

User avatar
om_tech_support_JT
Posts: 1058
Joined: Fri Mar 12, 2010 2:59 pm
Location: Torrance, CA
Contact:

Using the TMP-1 Torque Motor Controller to Stop a Motor

Postby om_tech_support_JT » Wed Dec 01, 2010 7:03 pm

Q: Is the TMP-1 capable of dynamic braking or instantaneous stopping an AC torque motor?

A: No, the TPM-1 is only capable of coasting to a stop, there is no instantaneous stopping. The motor will have about 30-40 revolutions of over-run (at motor). Depending on the gear ratio being used (if applicable) along with the amount of friction, this may be reduced.

Return to “AC Motors”

Who is online

Users browsing this forum: No registered users and 2 guests